Introduction #
While working in the field, interruptions happen—whether it’s a short break or the end of the day. If you didn’t finish your linework, don’t worry! You can always continue where you left off.
Here’s a short tutorial on how to do that.
Video #
Step-by-Step Workflow #
- Select a Feature Class
- Choose a line-based feature class (either Line or Line with Points).
- Choose a line-based feature class (either Line or Line with Points).
- Create a New Line
- Start surveying your line.
- Finish the line by tapping the checkmark button.
- Select the Line to Continue
- Tap on an existing line.
- Tap on an existing line.
- Enter Edit Mode
- Hit the edit (pen) button.
- Hit the edit (pen) button.
- Connect to GNSS
- Select “My Position” to link the measurement to your GNSS hardware.
- Select “My Position” to link the measurement to your GNSS hardware.
- Finish the Line
- When done, tap the checkmark again to save your changes.
Additional Info
This tutorial describes the workflow using GNSS hardware.
The same steps apply to manually created lines without GNSS.