Geolantis COLLECTOR

Mapping Line Features

32 views Hanie 1

Mapping line features in Geolantis.360 mobile app using My Position GPS mode requires feature class configuration of the feature class called ‘Locator’.

     The line feature class that will be used for mapping must be linked as a higher category of ‘Locator’ feature class

During data collection, Geolantis mobile field app will automatically create Locator points along with the nodes of the line being mapped.When Geolantis connects to utility locating equipment, the Locator points will hold attributes such as depth value of underground features as well as sensor data.

Define higher categories of the Locator feature class as follows:

  1. Go to the Feature Classes page
  2. Select Locator  feature class
  3. Click on Edit to configure feature class
  4. Select the required line feature class for mapping as a higher category
  5. Save and close the feature class properties window

In the mobile field app, start adding features in  My Position (GPS) mode or Record Manually as follows:

  • Click on the Place button   to start mapping.
  • Select feature class with  line feature type.
  • Click on the activated Place button   to create a new point. Geolantis field app will automatically create Locator points along with the nodes of the line being mapped.
  • To continue mapping, start walking while collecting data in the My position (GPS) mode, or select other location on the map for Record Manually mode and place new points.
  • Click on the Done  button   to save and sync the collected features or click on the Cancel button  to abort the mapping.
  • Optional: Activate the Distance Auto Recording  for frequent points mapping in My Position (GPS) mode.
  • After data synchronization is completed, the created features can be viewed and exported from the Features page at Geolantis.360 web portal.
      Click here to learn more about Distance Auto Recording in Geolantis.360

 

 

Was this helpful?